Drėgmės filtras mini "Yato" (YT-2380)

TECHNICAL DATA. Maximum working pressure: 1.4 MPa. Thread diameter of the air connection: 1/4 ". Maximum working temperature: 60 degrees Celsius. Tank material: Polycarbonate. Tank capacity: 8 cm3. INSTALLATION GUIDE. Place the device in a vertical position with the tank facing down.. Make sure that the connection is tight.. The filter should be placed in the pneumatic system as close as possible to the unit to which the filtered air is to be delivered.. Avoid exposure to direct sunlight, high temperatures and corrosive chemicals.. The water tank should be located below the water drain valve so that water can flow into it.. CONTROL. Dropping water. If there is no pressure, the water will automatically flow out.. If the device is under pressure, open the drain valve located on the bottom of the tank to allow water to fall.. If the water level exceeds the maximum allowable range, open the drain valve and let the water flow out. This will maintain the optimal humidification of the flowing air.. MAINTENANCE. Turn off the air supply, air collected under pressure in the pneumatic system let out into the atmosphere.. Turn the tank counterclockwise.. Clean the filter with clean, compressed air.. Clean the inside of the tank with a soft, dry cloth.. Do not use any solvents or other substances that could destroy polycarbonate.. Before screwing the reservoir retaining ring, make sure that the gasket is in place and not contaminated.. Technical data. Index number YT-2380. EAN 5906083923807. Brand Yato. Gross weight (kg) 0.1240. Master Carton MC 50. Inner Box IB 25. Pal 3000. Working pressure [MPa] 1.4. Max inlet pressure [bar] 14. Capacity [cm3] 8. The size of the quick connector [inch] 1/4 ". Thread diameter [in] 1/4 "