Mikrometras skaitmeninis | 0-25 mm (YT-72305)

Technical data. Measuring range: 0 - 25 mm. Resolution: 0.001 mm / 0.00005 inches. Accuracy: 0.002 mm / 0.0001 in. Measuring force: 5 - 10 N. Display: liquid crystal display LCD. Current consumption: 35 A. Power supply: one 1.55V silver battery, type SR44. Working temperature: 5OC - 40OC / 41OF - 104OF. Storage temperature: -20OC 60OC / -4OF 140OC. Effect of humidity: no matter less than 80% relative humidity. Destination / Application. For precise measurements and easy readings from 0 to 25 mm.. How to use. Preparing for work:. - Clean the measuring surfaces and guide. For this purpose use a cotton cloth. Do not use solvents or acids.. - Check the zero position for this purpose, touch the measuring surfaces by turning only the friction clutch knob. Then press and hold down the ON / OFF SET button for about 2 seconds until the indicator is reset.. - Check that all buttons, switches and display are working properly.. Basic measurement methods:. 1. Absolute measurement. - Loosen the retaining clamp.. -Enable the device by pressing the "ON" button. Select the measuring unit by pressing and holding the "ABS / INC UNIT" button for about 2 seconds. Each time the measurement results will alternately appear in inches or millimeters. The inch score is described by the "in" symbol on the display screen.. Press the "ABS / INC UNIT" button until the "ABS" symbol appears on the display.. - Move the measuring surfaces a little wider than the object being measured.. - Then, by turning the spindle knob, set roughly, then continue to tighten by turning the clutch knob. Stop tightening when the coupling works.. - Read the measurement result from the display.. 2. Relative measurement. The principle of measurement corresponds to the above described, but relative measurement serves to compare two dimensions.. - When the "ABS / INC UNIT" button is pressed, the indication will be reset and the display will show "INC". After re-measuring, you can read the difference in dimensions.. The micrometer is equipped with a steel ball in a rubber mount that allows mounting on the measuring surface of the micrometer. It facilitates the measurement of small surface elements. Once it has been set, reset the display according to the procedure described above.. Warning! It is recommended to mount the measured element or micrometer before starting the measurement. This will allow you to achieve the highest measurement accuracy. It is also recommended to perform several measurements to obtain the arithmetic mean of the results.. Technical data. Index number YT-72305. EAN 5906083723056. Mark Yato. Unit SZT. Gross Weight (kg) 0.4750. Master Carton MC 20. Pal 640. Material steel. Weight [g] 475. % santykinei dregmei